20ft Aluminum Airboat with 495 HP Motor

Lenth: 5.8m

Width: 2.2m

Thickness of bottom : 5mm

Thickness of Side: 3mm

Materials: 5083 H111 marine aluminum plate

7 pcs 50x50 T Bars

3 Transom Ribs

6mm ploymer on the bottom

Aluminum anti-skip deck with foams

Aluminum Top Rails

3 bench seats and one driver seat

Max Passenger：8

Multi-Port fuel injection Instant starting

Precise throttle response

Outstanding cruising and top-end performance Increased fuel efficiency

Engine Management System

Specially calibrated for the rugged airboat application Knock sensor adjusts for low octane fuel

Automatic spark control provides peak performance in all operating conditions Monitors the vital signs of the lubrication and cooling systems

Rev limiter prevents engine damage for over revving Fuel Control System

Eliminates vapor lock

Protects EFI system against contaminated fuel Premium, extra large fuel filter/water separator Easy to reach and service

Distributorless Ignition

Coil-near-plug ignition system

No points, rotor,condenser or cap

Platinum-tipped spark plugs Longer maintenance intervals Lubrication System

Full pressure full flow filtering system Positive crankcase ventilation Custom all-weather engine cowling

Owners and parts manuals by Pleasurecraft, the airboat industries largest engine and parts supplier

Single serpentine belt

Multi-coat non-corrosive paint

U.S. Coast Guard approved flame arrester Warranty- 1 yr warranty

Electrical System -Enhanced wire harness to meet rigorous Airboat demands Electronic Ignition

12 volt negative ground system High output 100-AMP alternator

Overload damage protection by a manual reset circuit breaker Pre-wired wiring harness with 10 prong disconnect

High-torque positive engagement bottom mount marine starter Temperature,oil pressure and voltage

ENGINE REDUCTION UNIT

Century belt reduction unit 2.3 to 1 Ratio PROPELLER

5- Blade 79" adjustable pitch composite propeller

ENGINE STAND

Automotive Built of 1 " stainless steel tubing (16 gauge)

6- mounting points for automotive (Moog Mounts Rear) (Prothane Mounts-Front) All mounts to be shock mounted to prevent vibration

Mounting bracket to be incorporated into the engine stand for the 40 gallon fuel tank Dual battery rack to be built in the engine frame